Slicer Discord
OBSERVATIONS - NOTES – Modelo 3D imprimible de Thingiverse Thingiverse

OBSERVATIONS - NOTES

por BETLOG
8 Descargas
13 Likes
0 Makes
Ver Modelo
Stuff I noticed. You'll need to figure out which image each bullet point refers to. It should be fairly obvious.

- modprobe cp210x
I have a trigorilla 1.3 board that I removed from my i3 becausee I couldn't flash it with new firmware FROM SOURCE due to Anycubic's classic misuse of the Marlin Opensource License. Fast forward several years and now there is reverse engineered source available, and Marlin has trigorilla board pin definitions included... so I have - again - been trying to flash and go back to using it. Problem being that it was unrecognised as a tty/usb device when i plug it into my linux machine. So for the dozenth time I do a bit more googling and happen to notice the 'feature' reference to the serial chip.... googled that...turns out all i need to do is "modprobe cp210x" and suddenly I can flash the board. YAY. Now I can put it's guts back inside the case ...as opposed to being strewn over my desk like the RAMPS has been for the last year+... and use most of the orig
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección