Obtuse Mag Holder

Much thanks to Reagantoby27 for helping me redesign and test the evolution from V1 to V3 and all its variants.Holds a mag, at an angle.Designed off of Glock 9mm mags, not sure what else it will fit. It "should" fit SW40 and 357 as well.Inspired by the Recovery Tactical MG9 Angled Mag Pouch.***Inside of the magwell in V3 & V3.1 are a series of bumps that can be sanded down if your magazines fit a little too tightly.Variants:V3: All in one package, just print V3 and Clamp. Its good enough.V3.1: Has removable mag catch tabs. Print V3.1, the Tabs and Clamp. Tabs can be replaced if worn out or broken, can also be adjusted with a little heat for more or less clamping force. I have included blank tabs in case you want to customize your own tabs.V3.2: Has an actual mag release to ensure mags cannot fall out. Print V3 MagLock, Mag Release and Clamp. The Mag Release can be reversed and used from either side of the grip depending on personal preference.Hardware:1x M4x30mm bolt and nut for