Thingiverse
Oceans Population Board
door mabegerr
5
Downloads
4
Likes
0
Makes
Used in tandem with these printed fish:
https://www.thingiverse.com/thing:4138216
Recessed slots for holding the fish tokens in place.
It's important to use .2 mm layer height because everything was designed in those increments.
I used the Gyroid infill in Cura to get some wavy patterns that you can see inside the print.
https://www.thingiverse.com/thing:4138216
Recessed slots for holding the fish tokens in place.
It's important to use .2 mm layer height because everything was designed in those increments.
I used the Gyroid infill in Cura to get some wavy patterns that you can see inside the print.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!