MakerWorld
Gadgets
Zum Modell
Oculus CV1 Sensor Wall + Ceiling Mount
20
Downloads
5
Likes
9
Makes
This is a wall & ceiling mount for the Oculus Rift CV1 sensor.When you put it on a wall, the sensor sits upside down but it works fine.For the 3rd sensor I mounted it on the ceiling like in the 3rd photo, so you can adjust the angle a little bit better.There are also little holes to use zip ties for the USB cable.Print SettingsUse brim for better adhesionPost-PrintingScrewing in the sensorAfter printing both parts, you unscrew the sensor from the old stand and put the printed screw into the front hole. Then you put the sensor to the other side of the hole und screw the sensor with a screwdriver.Screwing into the wallYou drill a hole into the wall and put a dowel in it.After that you use a fitting screw and screw it into the hole.Use zip ties to hold the USB cableYou can use the two "bridges" on the holder to zip tie your cable.But don't tie them to much, otherwise the bridges can break.Manual adjustmentsWhen using the setup tool in Oculus App, you can adjust the angle, heig
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!