Oculus Go Pistol

I looked everywhere for a good gun controller for the oculus go and came up with nothing, so I used NoobTube's pistol grip and combined it with a cool Halo gun that I found. I split them into parts for printing. The one downside of this gun is that you do not have easy access to the buttons and pad on-top of the controller. I would suggest 10% infill for everything except the back of the gun and 25% for the back if you are printing in ABS, and 50-100% if in PLA. The reason I suggest this is, I needed the weak point in the back to be plenty strong. For printing you can either print the full gun, you can print the back, middle, and front. Or you can print the back and full front. I used super glue to connect the pieces and so far it has held up. I used the creality ender 5 for the front and the QIDI tech 1 for the back. Printed the front of the gun laying down and the back standing up, Both need supports everywhere. The front took 13 hours and the back took 8.