Electronics
Model downloaden
Oculus Meta Quest 2 Strap Cable Holder
1.4k
Downloads
316
Likes
960
Makes
This is a remix as the one I printed was for the elite strap and I found that it would easily come off of the standard strap. So I adapted it to fit the standard strap. Works great so I thought I would share :-) Simple cable clip for the Oculus / Meta Quest 2 Standard Strap. Designed around the official Oculus Link cable, but will work with others. the Cable in the picture is an aftermarket one that also powers the headset in use. I also have the standard cable and it works perfectly with both. I hate the cable dangling and hate just QR cable tying it on. I have printed it in PLA+ and it works perfect! 15% infill too. 1 x clip uses 2.39g and takes 12m 31s on the P1S 2 x clips uses 4.69g and takes 16m 47s on the P1SI liked two clips. One on the side and one on the rear so the cable goes more down my back, but one or two is fine :-)Enjoy. *** Side note - I have also tried it on the Quest 3 strap and it also works on that. The Quest 3 strap does appear to be a couple of mm's taller th
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!