Thingiverse
Oculus Quest 2 Battery mount Remix
von halfblood11
5
Downloads
3
Likes
0
Makes
Printed without supports
30% infill is probably overkill
printed at 100% scale it is fairly loose on the mount (cable tie added some resistance)
can be used also just to add some weight to the back of the headset
i wasn't sure how much space the original one had, so I removed the clip piece and added a cable tie slot
with the cable tie adjusted correctly, it allows the pack to be slid out (it doesn't just fall out)
30% infill is probably overkill
printed at 100% scale it is fairly loose on the mount (cable tie added some resistance)
can be used also just to add some weight to the back of the headset
i wasn't sure how much space the original one had, so I removed the clip piece and added a cable tie slot
with the cable tie adjusted correctly, it allows the pack to be slid out (it doesn't just fall out)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!