Thingiverse
Oculus Quest to Vive DAS conversion D ring
von willnewton
74
Downloads
34
Likes
0
Makes
This is a D-ring I made as a part for converting the Oculus Quest to Vive deluxe audio strap.
Works well. Is plenty sturdy enough as well, even in PLA.
I used .25mm layer heights, 3 layer tops/bottoms, and 4 perimeters.
The Velcro side of the ring is fine for 7/8" and 1" Velcro tie straps. In the pic I am using a 7/8" strap.
Works well. Is plenty sturdy enough as well, even in PLA.
I used .25mm layer heights, 3 layer tops/bottoms, and 4 perimeters.
The Velcro side of the ring is fine for 7/8" and 1" Velcro tie straps. In the pic I am using a 7/8" strap.
willnewton veröffentlicht auch auf
127 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!