Thingiverse
Oculus Rift Camera Truss Mount
door ha5dzs
2
Downloads
4
Likes
0
Makes
This is an 'h'-shaped clamp that goes on trusses with 50mm diameter pipes.
Tensioning is done with cable ties.
There is no need for special print settings, should print without extra support.
Lay it on the side before printing though :)
Tensioning is done with cable ties.
There is no need for special print settings, should print without extra support.
Lay it on the side before printing though :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
