Thingiverse
Oculus Rift sensor wall mount
door ransoing
88
Downloads
49
Likes
0
Makes
This is a wall mount for Oculus Rift (CV1) sensors. The sensor is mounted upside-down, because it can tilt toward the ground further when mounted that way, which makes this mount suitable for placing near the ceiling.
The sensor is not mounted at an incline, which maximizes the tracking area. In case you need it, the mount has a hole for a zip tie to secure the sensor better (see the photos from the remix source).
Changes from the remix source:
* The sensor is mounted on the same side as the vertical part of the mount, reducing the visual footprint.
* The back of the mount has a spot to feed the cord into, which makes for a cleaner look, especially if you put a cord channel/conduit directly below the mount.
The sensor is not mounted at an incline, which maximizes the tracking area. In case you need it, the mount has a hole for a zip tie to secure the sensor better (see the photos from the remix source).
Changes from the remix source:
* The sensor is mounted on the same side as the vertical part of the mount, reducing the visual footprint.
* The back of the mount has a spot to feed the cord into, which makes for a cleaner look, especially if you put a cord channel/conduit directly below the mount.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
