Thingiverse
Gadgets
Zum Modell
Oculus Touch Wallmount
288
Downloads
217
Likes
6
Makes
I needed a wall mount for my Touch Controllers, so I quickly put this one together. Prints straight forward on its back plate without supports.
If your screws are larger than the holes it comes with just drill them out a little bit.
If your screws are larger than the holes it comes with just drill them out a little bit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
