Thingiverse
Ocusync QAV Antenna Mount
von Totnacht
6
Downloads
2
Likes
0
Makes
This is a flexible antenna holder for my new Ocusync system and my QAV210.
The holder is mounted at the last 2 screws of your frame.
You then can simply insert the two ocusync antennas and install them into the air unit.
Fix them with small zip ties around the pipes.
There are two versions, a smaller one with more clearance and a bigger one with more flex, but less room for installation.
To get it to work with PETG and ABS I'd advise you to cut a notch of the double size of your zip tie into the tube to give it enough play to be condensed down on the antenna tubing.
Fly-Safe and have fun.
The holder is mounted at the last 2 screws of your frame.
You then can simply insert the two ocusync antennas and install them into the air unit.
Fix them with small zip ties around the pipes.
There are two versions, a smaller one with more clearance and a bigger one with more flex, but less room for installation.
To get it to work with PETG and ABS I'd advise you to cut a notch of the double size of your zip tie into the tube to give it enough play to be condensed down on the antenna tubing.
Fly-Safe and have fun.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
