Thingiverse
Oddish
by rossaboss
1
Downloads
2
Likes
0
Makes
PLEASE READ BEFORE PRINTING: IF YOUD LIKE TO PRINT i have some tips because it will not print as is.
an attempt at oddish using tinkercad! was extremely bored at work so i dont know how well this will print
10/9/25 just started printing, already definitely considering using brim and supports, will update later
10/10/25 two failed print attempts, would upscale and change the infill to concentric
10/10/25 part two: FOUR failed print attempts, turned it over on its back and changed the infill once more, we are getting warmer. Printing it upright with supports causes the feet to break off with removal. However if you flip it on its back the feet dont break, now i need to make sure the face stays recognizable because these past five tries just butchered our poor boy oddish
an attempt at oddish using tinkercad! was extremely bored at work so i dont know how well this will print
10/9/25 just started printing, already definitely considering using brim and supports, will update later
10/10/25 two failed print attempts, would upscale and change the infill to concentric
10/10/25 part two: FOUR failed print attempts, turned it over on its back and changed the infill once more, we are getting warmer. Printing it upright with supports causes the feet to break off with removal. However if you flip it on its back the feet dont break, now i need to make sure the face stays recognizable because these past five tries just butchered our poor boy oddish
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
