Odin Speedloader Handle

A while ago, my handle for my odin speedloader came off and is lost somewhere. This happens more often as this is considered to be one of the points of failure for the odin speedloader. For some reason, there aren't any spare handles being sold. So I decided to not only make a handle that fits, but also reduce the chance of it coming off again.


Hardware required:

1x M3 lock nut
1x M3x30 countersunk screw
1x M3 washer or a gearbox shim

Instructions:

First, you push in the lock nut flat end down into the hex shaped hole. It may be a tight fit so you might have to use a mallet to pound it in. Then you put the screw through the odin speedloader. From there, place the washer on to the screw and then you screw in the handle skinny side first. Make sure to use a set of pliers or vice grips to carefully screw in the handle all the way till it catches the nut.


This is my first time ever drafting an object and my first upload on this site. Let me know what you think.