ODROID H3 minimalistic case

This is my take on an ODROID H3 / H3+ Case. It is inspired by the Mac mini and houses the ODROID H3 along with a 120mm fan and a MeanWell Power Supply (75W is massively overrated, the 35W variant should also fit and give you a bit of extra space). The whole case is designed with quite tight clearances, so make sure your printer is tuned well. Assembly is not very easy as everything is quite tight to minimise the footprint. It does all fit together though and there is enough room for airflow. If you use common sense there should be no issues.The only gotcha is the Power Button - the GPIO pins of the H3 are inaccessible once it’s inside the case, so I recommend adding a plug to the cable that is connecting the power button. This way you can plug everything into GPIO while the H3 is out of the case and then just plug the button in later. The button can only be fully mounted after the H3 tray is secured, otherwise the screw won’t fit.Be careful when you wire up the PSU. The voltages can an