Odroid XU4 Case

While it isn't perfect, it prints a lot better than the others that are available right now. Feel free to remix it if something is missing.

## Important Notes

1) This case is not designed for the SD card slot. You may need to cut a hole for it if you're using the SD slot. If you're using an EMMC only, then no worries, you're all set.
2) Depending on how the SD/EMMC selector switch was soldered onto your XU4 board, it might be a little bit of a tight fit. You may need to slightly clip the EMMC / SD switch plastic on your XU4 (the white plastic can stick out quite far but is super easy to clip to a lower profile).
3) If you require the reset switch or any of the breakout pins, you may need to cut some holes into the enclosure using your favorite CAD software.
4) This design is for the FAN version of the XU4 (actively cooled)

## Printing

1) No hardware or glue required. Face-plate is held in place through pressure.
2) You may need to print this at 1% larger, depending on h