Thingiverse

Off-set Lift-Off Hinge

von Athruz

85 Downloads

35 Likes

0 Makes

SO this was sorta of necessity and one of the reasons I love 3D printing. I sorta misjudged the depth of my lack enclosure and my 13 mm Plexiglas surrounds caused the door not to shut. If I pushed the printer back far enough for the door to shut the bed hit the back wall before it met the end stop. I know, I know I should have measured twice and cut once so to say but hindsight being 20/20 I had to adapt.

So.... I made these offset hinges to "push the door out the thickness of the Plexiglas. These need to be strong if you print them and have thick ass Plexiglas as I did.\

*** This is only for right swing/side hinges, I did not draw any of these for the left side. The pin orientation is what makes them left and right sided due to the lift off ability. Tight tolerances since I wanted them to be strong.

3d printer enclosure enclosure fusion fusion 360 hinge hinges ikea ikea lack lack offset plexiglass prusa mk2s 3d printer enclosure enclosure fusion fusion 360 hinge hinges ikea ikea lack lack offset plexiglass prusa mk2s 3d printer enclosure enclosure fusion fusion 360 hinge hinges ikea ikea lack lack offset plexiglass prusa mk2s 3d printer enclosure enclosure fusion fusion 360 hinge hinges ikea ikea lack lack offset plexiglass prusa mk2s 3d printer enclosure enclosure fusion fusion 360 hinge hinges ikea ikea lack lack offset plexiglass prusa mk2s

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat