Offset Heat Set Insert Snap for Multiboard 3mm

This is a re-mix of the Heat Set Insert Snap - M3 Standard & Short - 3D model by Keep Making on Thangs with slightly offset fixing holes to allow you to mount bolted accessories with non-25mm fixing centres. This Snap requires you to install “M3 Heat Set Threaded Inserts” using a soldering iron. Four models are provided with varying offsets from the centre of the snap: 1mm, 1.5mm, 2mm and 2.5mm. Each snap is marked with a symbol to show the offset to make it easy to select the correct snap if you print off different versions. As a guide, I had a screw-mount multi-meter bracket with fixing centres of 29mm. I used 2 x '2.0mm Offset Heat Set Insert Snap M3' to give 25mm + 2mm +2mm = 29mm centres. Depending on the orientation the snaps are installed this gives various options between 5mm below and 5mm above the standard 25mm Multiboard centres. Here are the recommended M3 Heat Set Inserts that work with this Snap: M3 Short: https://cnckitchen.store/products/gewindeeinsatz-threaded-