Thingiverse
Offset Marker
por pvico
2
Descargas
0
Likes
0
Makes
This tool is used to draw a line with an offset to an object. It is made for an Artline 70 marker or any similar marker with a 15mm diameter.
Use the rubber band as shown on the photo, only a very slight downward pressure is required otherwise the marker tip will be pushed inside the marker body.
Alternatively, the two M3 screws can be tightened a bit more to block the marker in the tool.
Files are included for 15, 20 & 25mm offsets.
Needs 2 x M3x6mm (or longer) screws and a rubber band.
On the photo, I am using it to draw the offset contour of the stabilizer of one of my radio controlled sailplanes. This aluminized foam film is normally used for thermal isolation.
I use it to make protective covers for RC models.
Use the rubber band as shown on the photo, only a very slight downward pressure is required otherwise the marker tip will be pushed inside the marker body.
Alternatively, the two M3 screws can be tightened a bit more to block the marker in the tool.
Files are included for 15, 20 & 25mm offsets.
Needs 2 x M3x6mm (or longer) screws and a rubber band.
On the photo, I am using it to draw the offset contour of the stabilizer of one of my radio controlled sailplanes. This aluminized foam film is normally used for thermal isolation.
I use it to make protective covers for RC models.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!