MakerWorld
Other House Models
Zum Modell
Offset Sink Tailpiece 1.5"
1
Downloads
0
Likes
1
Makes
The way my plumbing was oriented under my laundry room sink meant that I couldn't connect it properly, because the p trap interfered with the house drain line. My solution was to give the sink drain just a little nudge off to the side, just enough to allow everything to connect as it should.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!