Thingiverse
OG Chameleon GoPro Session Mount
door caseyjholmes
14
Downloads
11
Likes
0
Makes
GoPro Session Mount for OG Armattan Chameleon. Print with supports. Retraction helps remove strings. Print with TPU at 230* nozzle, 70* bed, 30mm/s.
To install, slip carbon plate inside mount. Set mount and plate into position on airframe.
Bend the mount out of the way of the screw holes to install the screws. Don't worry, if you used TPU, it should bend out of the way to install the screws just fine.
Insert session through the back before installing flight battery.
Features an SD card door slot for removing the SD card and charge the camera.
Contact me if you need custom fitted designs.
Enjoy!
-Casey
To install, slip carbon plate inside mount. Set mount and plate into position on airframe.
Bend the mount out of the way of the screw holes to install the screws. Don't worry, if you used TPU, it should bend out of the way to install the screws just fine.
Insert session through the back before installing flight battery.
Features an SD card door slot for removing the SD card and charge the camera.
Contact me if you need custom fitted designs.
Enjoy!
-Casey
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
