Slicer Discord
OHUHU - Stackable Marker Pen Holder – 3D printable model from MakerWorld MakerWorld
Organizers

OHUHU - Stackable Marker Pen Holder

1.5k Downloads
563 Likes
534 Makes
Go to Model
NEW AND IMPROVED VERSION AVAILABLE CLICK HERE!A stackable OHUHU marker holder. These markers are 15ish mm in diameter. This design is based on my design for the Tooli art Markers and again a wish from my girlfriend for a more accessible storage for her markers.I also have made a lid and slanted foot for this organizer and will upload those soon too. I will add links below when so.Again I've made sure to try and keep filament and print time as low as I can with my knowledge. One tray should be around 80 grams.These also have a little compartiment to hold a 4x1,5 mm magnet to keep it al a bit more toghether. But from my experience it is not needed and one should not stack too much in one pile.It's made to be printed starting on its back.It should not require support, but keep speeds within a reasonable setting.
Category
Organizers
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

3 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection