Thingiverse
Engineering
Model downloaden
oil filter remover
19
Downloads
10
Likes
0
Makes
I have printer this with 50 percent infill to ensure it will be strong enough.
I have designed to fit a half inch ratchet and is also able to fit a 24mm socket or spanner. i have made this so that i can remove the oil filter off of my car and by simply adding a cut off of an old belt and a small bolt it is cheep and works great.
As you turn the oil filter remover it tightens the strap so that it can fit all sizes of oil filter.
When putting the new oil filter on to your car you should only put it on hand tight and it should be primed with oil, so please only use this tool to remove the filter.
the size i have cut out for the nut and bolt is:
nut - 6.7mm.
bolt - 3.8mm hole with 6mm head.
I have designed to fit a half inch ratchet and is also able to fit a 24mm socket or spanner. i have made this so that i can remove the oil filter off of my car and by simply adding a cut off of an old belt and a small bolt it is cheep and works great.
As you turn the oil filter remover it tightens the strap so that it can fit all sizes of oil filter.
When putting the new oil filter on to your car you should only put it on hand tight and it should be primed with oil, so please only use this tool to remove the filter.
the size i have cut out for the nut and bolt is:
nut - 6.7mm.
bolt - 3.8mm hole with 6mm head.
MattMo3D publiceert ook op
16 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
