OIl Separator
von resago
8
Downloads
7
Likes
0
Makes
This is an oil separator that I designed for my car.
vapor in and out are made for a 1/2in copper pipe. out is at the top next to the cap.
oil outlet is smaller, find something to work.
the tabs on the side are to hold down the cap with wire or bungee cord.
The cyclone effect should work well at slinging the oil to the sides,leaving dry-ish vapor.
print upside down without supports.
probably want to print 100% infill, or close to it.
ABS or nylon.
you may want to print at 110%
vapor in and out are made for a 1/2in copper pipe. out is at the top next to the cap.
oil outlet is smaller, find something to work.
the tabs on the side are to hold down the cap with wire or bungee cord.
The cyclone effect should work well at slinging the oil to the sides,leaving dry-ish vapor.
print upside down without supports.
probably want to print 100% infill, or close to it.
ABS or nylon.
you may want to print at 110%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
