Thingiverse
Oldham_Printable
von der_stobi
1
Downloads
0
Likes
0
Makes
Oldham Coupling_V2. fiirst one was too weak and also I crashed the bed. Opps.
has to be print at at least 0.1/0.4mm Nozzle. I printed it in PLA, Sanded it smooth with a 800 Grid Sandpaper (wet Sanding) and used Polish for the final finish, just so the two sufaces could wear into each other. After that I used Grease as a Lubricant
has to be print at at least 0.1/0.4mm Nozzle. I printed it in PLA, Sanded it smooth with a 800 Grid Sandpaper (wet Sanding) and used Polish for the final finish, just so the two sufaces could wear into each other. After that I used Grease as a Lubricant
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
