Thingiverse
OLED Name Tag
door JOHNNYBOI
1
Downloads
2
Likes
0
Makes
This project uses an Arduino Nano - powered by a 400mAh 3.7V battery hooked up to an on/off switch, a charging module, and a 3.7V-5V step up module - to display images on the attached .96" OLED l2C screen. It can attach snugly to your pocket.
If I were to suggest changing anything I would make the "body" model very slightly bigger.
The image displayed is a test placeholder being used while I customize the code.
The back is held with tape which is out of view when inside one's pocket. The clip is held to the body with glue, and the screen to the clip with glue as well.
If I were to suggest changing anything I would make the "body" model very slightly bigger.
The image displayed is a test placeholder being used while I customize the code.
The back is held with tape which is out of view when inside one's pocket. The clip is held to the body with glue, and the screen to the clip with glue as well.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!