Olight Obulb Hook

This is a simple hook for the olight obulb.

There are 2 versions:
ObulbHook-OlightDisk
Use the disk that comes with the obulb to stick to the hook.


ObulbHook-m3Inserts
Use m3 inserts and screws for the bulb magnet to stick. This base has a smaller diameter but is thicker for inserts.
I originally created it with only 2 inserts/screws but the light would fall off when rattled. 4 seems to keep it on fairly tight.
I used a soldering iron to get the inserts/screws into the holes.

Printed with a raft and support but probably only support is needed.
(hanging the light from the printer cables was for the photo, I do not normally keep it there!)

The source of the hook is a design on tinkercad from Davenport switcher here:
https://www.tinkercad.com/things/54AAjumMsDR-hook