Thingiverse
Olympus E-M1 II grip replacement
door martin_au
26
Downloads
17
Likes
0
Makes
A replacement grip for the Olympus E-M1 II. I printed it out of Nylon + CF.
There's a tiny lip at the base of the grip, around 0.6mm deep. This small lip may need to be filed down slightly on the lens side until it fits, while remaining intact on the outer side. This is necessary as it allows the camera grip to fit the camera very, very securely.
Update: Added the rear grip too, with a nice textured surface.
An updated version is available here: https://www.etsy.com/au/shop/CartesianCreationsAU
There's a tiny lip at the base of the grip, around 0.6mm deep. This small lip may need to be filed down slightly on the lens side until it fits, while remaining intact on the outer side. This is necessary as it allows the camera grip to fit the camera very, very securely.
Update: Added the rear grip too, with a nice textured surface.
An updated version is available here: https://www.etsy.com/au/shop/CartesianCreationsAU
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
