Thingiverse
Olympus E-P7 grip
di drosen
1
Download
1
Likes
0
Makes
Grip for the Olympus / OM-System E-P7 camera.
There is a hole for a tripod screw on the bottom, this should ideally be tapped with a 1/4-20 tap. The second partial hole is designed to fit a brass 1/4-20 insert.
I've included the original OpenSCAD file should you need to make changes to the design.
Caution: Be very gentle with the Battery door / cutout. Pushing too hard on the battery door of the camera can cause it to pop off. Usually it can popped back into place, but I take no responsibility for your camera. If this doesn't work for you, feel free to customize the design as needed.
There is a hole for a tripod screw on the bottom, this should ideally be tapped with a 1/4-20 tap. The second partial hole is designed to fit a brass 1/4-20 insert.
I've included the original OpenSCAD file should you need to make changes to the design.
Caution: Be very gentle with the Battery door / cutout. Pushing too hard on the battery door of the camera can cause it to pop off. Usually it can popped back into place, but I take no responsibility for your camera. If this doesn't work for you, feel free to customize the design as needed.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
