Olympus Trip 35 Shutter Button

This is a replacement shutter button for the Olympus Trip 35. It is a small part so print slowly with thin layers.

Note: You may need to adjust the shutter screw to get the button to sit properly. The button should rest with the outer rim sitting on the metal lever with the screw inside of it. If you notice that the red flag behaviour changes when you install the button then the screw is too high, causing it to hold down the lever slightly. If it is too high you will notice that when you go from bright light (seeing no red flag) to no light then the red flag may not activate, or vice-versa from dark to bright.

Printed in PLA with a Bambu Labs P2S with 0.2mm layer height.