Omen X27 vesa mount

This is by no means perfect but I made this for my HP Omen x27 as no one else seemed to have a compatible one uploaded,

This was only the third revision of this and my first to fit on the stand well enough to be usable so I just left it as is and it's been fine for about 2 weeks now,

The Vesa mount is 100x100 and the holes are 3.5mm in diameter.

The print could definitely be improved as the clip on the bottom doesn't slot in correctly and the monitor I'm pretty sure sits at a slight angle because I tried to account for the slope on the stand incorrectly, but for my use case holding a square dell monitor as my second screen it has done its job pretty well,

I printed 50% infill with a .28 layer height, and mine hasn't broken yet anyway. However, I probably wouldn't trust this with too heavy a monitor. My Dell E197FP is only about 4 kg, and I don't care too much about it, so be careful about going heavier.