Omnistand Remixed

This is a remix of https://www.thingiverse.com/thing:667473

Instead of 3d printing the entire length of the rod, this uses 19mm wardrobe rail available from most DIY stores.

This has the following advantages
- low friction surface for the reel and adapters to move on (Using Chrome plated pole)
- easily customizable to any length
- higher strength
- Massively reduced printing time

Use a small amount of glue to hold the adapter in the pole if you want but otherwise it should friction fit.

When using different 1Kg Filaments i found that the rod needed to be mounted between the lower and middle holes, so i made an updated version that will work for both sides