OMP M2 2020/Explorer Version UC Mounts

Hey All.

Hot on the heels of my original OMP M2 UC mount (https://www.thingiverse.com/thing:4169853) to allow the use of deeper LiPo's, I have got hold of a new Explorer version also and created the same mod.

Same idea as before, front crossbar dropped by 3mm to allow the taller LiPo's to fit when using the tray.
You can use this without changing the rear setup at all, the only thing that happens is that the tail not sits level and not racked upwards to lift the tail rotor away from the ground some more.

However I do have a rear Jumper R1F receiver and rear UC mount that gives back and extra 1mm of height to the rear. Please check my other things.

After printing it is advised to run a 1mm diameter drill through the holes to clean them up and all stock screws are used still.

Ian Contessa