omp m2 evo

Differences of the remix compared to the original
slightly changed for M2 Evo

It is best to print it nose up and using ‘Tree’ supports in Cura. I also add 2 extra manual supports on the right hand side in the Cura preview screenshot to give it a little more support while printing as seen in the Cura preview picture. I also enable brim to help a little more.

I use 0.2 layer height with ‘Use Adaptive Layers Maximum Variation' set to 0.05 and 'Adaptive Layers Variation Step Size' set to 0.025. This allows curves to look better with a variation of layer height from 0.15 to 0.25 and still not slow the print down too much.

OrcaSlicer description:

Main changes: nose-up to minimize supports; careful tree support painting; expanded default wall size to 0.6mm on an 0.4mm nozzle to make walls two layers rather than three, reducing printing time substantially