MakerWorld
Garden
Model downloaden
One-Piece Mouse Trap
1k
Downloads
202
Likes
718
Makes
This single piece mouse trap (well, except for the bucket and ramp) is a "Walk the Plank" style trap where, when the mouse gets near the end of the plank, a latch releases the plank on its springy support, causing the plank and mouse to flop forward into oblivion. The plank then automatically springs back onto the latched position ready for the next mouse. Just bait the end of the plank with a little dab of peanut butter. You will also need a standard 5 gal. paint bucket and the handy folding ramp I've included. Note that the 2-piece ramp prints as a single piece and breaks apart. Use a short length of 1.75mm filament as a hinge pin to connect the two ramp halves.Watch it go at: Print SettingsPrinter:UDIORafts:NoSupports:NoResolution:0.2mmInfill:15%Filament:Inland PLA Notes: Make sure you use PLA, as the spring is tuned for the springiness of that particular material. Category: Outdoor & Garden
LoboCNC publiceert ook op
313 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!