OnePlus 3 / 3T Wallet Case - Customizable

Optimized for Semiflex/Cheetah. Ninjaflex will probaly work, too.
Some softer types of pla may work, but the hinge can break eventually.

Customizable types: Wallet Case, Flip Case, Bumper
Customizable text: You can add your own name or signature in customizer, by default its "OnePlus"

Default settings:
Wallet Case with 3 credit card pockets, one extra pocket and an integrated stand.

Red case=Semiflex, transparent=Taulman PCTPE

We all suffer from bad bed adhision from time to time, why not use it to our advantage?
When adding a small air gap between layers they still adhere during printing but can be seperated to form pockets :-)
I used Simplify3D, not tested with other slicers.

If you have problems separating the layers add a small piece of tape at the air gaps during printing. Usually its enough to have a 3mm wide opening to insert a screw driver and succesively open the pocket. I used a piece of kapton tape for the stand only, you can see it on the picture (yellow