Thingiverse
Oneplus 6T Brodit Holder
door TotalRetribution
34
Downloads
21
Likes
0
Makes
This is a Oneplus 6T Brodit compatible mount.
Its designed to use the original clear case that comes with the phone and a right angle USB-C cable I purchased from ebay.
I have included an image of the cable but I have not included a link to ebay in case its against Thingiverse rules.
Im unsure the size of the 3 screws I used since they were some I had lying around. However I have measured them and the screw is 11.85mm long. The thread is 2.95mm wide and the head is 4.9mm wide.
Its designed to use the original clear case that comes with the phone and a right angle USB-C cable I purchased from ebay.
I have included an image of the cable but I have not included a link to ebay in case its against Thingiverse rules.
Im unsure the size of the 3 screws I used since they were some I had lying around. However I have measured them and the screw is 11.85mm long. The thread is 2.95mm wide and the head is 4.9mm wide.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
