Thingiverse
OnePlus One car mount
von Bozze1990
40
Downloads
37
Likes
0
Makes
It's a car mount for the OnePlus One.
It's a remix from ( OnePlus One car mount by Cagy ),
I edited the clip that inserts into your airvent in Fusion 360, and made it stronger than the original.
Print it on it's side with support, because the strength is less when printed flat because of the build layers.
Material you should use : ABS.
Because if it's a hot day PLA gets weak from the heat in the car.
Also just to be sure, print with a raft, because when it is printed on it's side, the contact surface with the printbed is minimal !
It's a remix from ( OnePlus One car mount by Cagy ),
I edited the clip that inserts into your airvent in Fusion 360, and made it stronger than the original.
Print it on it's side with support, because the strength is less when printed flat because of the build layers.
Material you should use : ABS.
Because if it's a hot day PLA gets weak from the heat in the car.
Also just to be sure, print with a raft, because when it is printed on it's side, the contact surface with the printbed is minimal !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
