Onewheel V1 Bumper

Bumper for the Onewheel V1. Use a soldering iron to install #10-32 threaded heat inserts into the holes- https://www.mcmaster.com/#93365a154/=182e9ua.

To print with the face of the bumper on the plate, rotate in X 155 degrees. The center flat face will be printed on supports, if you do that so it might not look as good. If you print as oriented, try to keep from generating supports in the holes.

There are holes on the sides that start on the inside, but don't go all of the way through. You can drill those out and install luggage or skate wheels with a 6mm shaft.

The bumper is 240mm long, so it will require a 250mm build plate. It won't fit diagonally in a 200mm square.