Сonstruction stapler handle

The handle of the construction stapler broke. I modeled and printed a new one.
I use a CURA slicer.
I was typing in the vertical position. But you can try to print in a horizontal position. So more reliably.
In the "Experimental" section, I turned on the "fuzzy skin" mode, so that the handle is better held in the hand during operation.
But the surface for fixing should be smooth, so you need to use the blocker supports, stretch it to the desired size and select special settings. Add "fuzzy skin" and remove the check mark.
I used tree support.
I printed ABS plastic, but can be any other, such as PLA or SBS. Importantly, the item firmly on the table. I didn't use the raft.

If you like it, you can support me by sending a few coins for tea :)
WMZ: Z315805724463
PayPal: [email protected]
https://www.patreon.com/MrDialmax
https://www.donationalerts.com/r/mrdialmax