OP-1 Stand

Hello everyone! I've been working on a design for an OP-1 stand for a couple of weeks now, and I think it's finally at the point where I should show it off a bit! This has been quite a fun project, and one that I am quite pleased with the outcome of. As mentioned in the post title, this stand is 3D printed in two parts, and as you can see it is held together by 20 brass rods (1/8").


The stand has some nice features that I'll walk you through now:

Aesthetics - it just looks really pretty in my opinion, let me know what your thoughts are!

Low profile - I aimed to make this stand add as little bulk to the footprint of the OP-1 as possible. The tops of the stand sit below the surface of the OP-1. The divots in the base of the stand allow the rubberized feet of the OP-1 to sit below the surface, giving a lower height to the overall package. The divots are specifically modeled to still allow airflow to reach the back of the OP-1 so that you don't have to worry about the st