OP-Z Brace/Support

My Teenage Engineering OP-Z was looking like a taco. After straightening it out, I decided I wanted to prevent any further warping and stop the back cover from bowing out in the center.
So I created this brace in two versions that can be clipped onto the OP-Z. (1) Standard (2) With the hole allows you to clip it on over any modules you have, like the Line In or the OP-Lab module.

If your device is not flat, you can always disassemble it, put the case in the oven at 100°C for about ten minutes, and then flatten it.

Printed on my Bambu Lab A1 Mini: 100% infill, PLA, printed on its side with no supports, using 0.08 mm or 0.16 mm layer height to ensure strength and minimal layer lines.