Thingiverse
OP-Zoo Bump Case
von Julien_Prudhomme
6
Downloads
4
Likes
0
Makes
Material used : Rubber 2.3mm thick
Device : Trotec 60W CO2 laser
Additional material :
2 snaps
yellow and black paint
Please note that the dimensions of the files are related to the thickness of the rubber and the elasticity of this material (it means that the sides of the case are a bit shorter - around 0.1 mm - than the real dimensions of the OP-z).
So make some test if you use another material than rubber or a rigid one, and do the suitable scaling for you :).
Device : Trotec 60W CO2 laser
Additional material :
2 snaps
yellow and black paint
Please note that the dimensions of the files are related to the thickness of the rubber and the elasticity of this material (it means that the sides of the case are a bit shorter - around 0.1 mm - than the real dimensions of the OP-z).
So make some test if you use another material than rubber or a rigid one, and do the suitable scaling for you :).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!