Slicer Discord
opel headlight support v2.2.2 – 3D-Druckmodell von MakerWorld MakerWorld
Test Models

opel headlight support v2.2.2

von Joko · Test Models
2 Downloads
1 Likes
1 Makes
Zum Modell
right I'm 99.999% sure this one will work, one you take it off the build plate, you will need a pair of tweezers to take out the sag on the inside of the thread, then you'll need to take the male thread and chase the treads, now remember its a reverse thread to be gentle. To chase, Place the main part (female thread) in a vice, then carefully align up the male thread and hand start it so its straight. then use a socket to chase the treads, and keep backing it off and then brining it back in again and then it will be able to be done by hand after a few time. its take a bit but it will work. hope this helps anyone it needs to
Kategorie
Test Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen