Open RC MSE-6 Mouse Droid

3D print your favourite Star Wars Droid on your 200x200 printer.
This is a 6:10 scale model of the MSE-6-series repair droid aka Mouse Droid.
Being based on parts from Daniel Norée's Open RC F1 car, it is fully RC.

Non 3D printed parts needed: You will need to get the same Electronics (motor + ESC + Servo) as the OpenRC F1, as well as the same 6 bearings and m3 nuts and bolts.

I couldn't have made this without being able to remix the following parts so please drop them a like:
-OpenRC F1 2017 updates, by barspin used for to make the droid RC
-MSE-6 Mouse Droid Top Greeblies, by JoyMonkey (scaled 60% and increased hole dimensions to fit m3 screws).
-Mouse Droid side circuit board by kchristley (scaled 60%)
-OpenRC F1 Gear with grub screw
-Reinforced Rear Axel for OpenRC F1 car