Thingiverse
openable Pokeball
by X_eleven_I
27
Downloads
106
Likes
0
Makes
A simple Pokéball. There are two types of files, the inner joint & outer joint (there is a comparison photo)
~instractions~
Print the two halves of the sphere, cut a little bit of your filament (18.5 mm), and put it in the hole.
~differences~
The outer joint can open more (cca 180°) than the inner joint (cca 95°)
~magnet~
If you want to use the magnet version, the size of the magnet is | H- 14mm | W- 5mm
--BEWARE OF SCALING THE JOINT ISN'T GOING TO WORK PROPERLY--
~instractions~
Print the two halves of the sphere, cut a little bit of your filament (18.5 mm), and put it in the hole.
~differences~
The outer joint can open more (cca 180°) than the inner joint (cca 95°)
~magnet~
If you want to use the magnet version, the size of the magnet is | H- 14mm | W- 5mm
--BEWARE OF SCALING THE JOINT ISN'T GOING TO WORK PROPERLY--
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
