Thingiverse
Openastrotracker Power Supply Box
door fiorucci
10
Downloads
7
Likes
0
Makes
This is a power supply box for the OpenAstroTracker project. An input power supply between 12vcc and 28vcc is provided through the "input" barrel jack, and the right voltages are provided to power:
- DSLR (8mm barrel jack)
- Arduino Mega (8mm barrel jack)
- Stepper motors (xh 2.54 connector)
- Raspberry Pi running Astroberry (USB, vcc and GND used only)
The DC/DC Step-Down converters used are MP1584 3A, 1.5MHz, 28V: https://www.haoyuelectronics.com/Attachment/MP1584/MP1584.pdf
Screws to close the box are M3, the two screws on the back side are M4 and can be used to screw it to the 2020 extrusions using T-nuts
- DSLR (8mm barrel jack)
- Arduino Mega (8mm barrel jack)
- Stepper motors (xh 2.54 connector)
- Raspberry Pi running Astroberry (USB, vcc and GND used only)
The DC/DC Step-Down converters used are MP1584 3A, 1.5MHz, 28V: https://www.haoyuelectronics.com/Attachment/MP1584/MP1584.pdf
Screws to close the box are M3, the two screws on the back side are M4 and can be used to screw it to the 2020 extrusions using T-nuts
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
