openBulletFeeder - Adjustable 1" Pipe Mount

This is an adjustable and lockable 1” pipe mount for the openBulletFeeder. There are improvements from the one included in the openBulletFeeder. The Bullet Feeder mount side is modified from the OBF file, so the usual fitment issues from the OBF will still be present. My parts should fit snug with enough tolerances to fit.

To adjust the tilt angle, loosen and tight the #4 screw on the plates, once it is fully adjusted,you can lock it with the 1/4" bolt.

I have included 2, 1” mounts, one with a top and the other open ended. I changed the OBF nut from a hex to a square nut. The hardest parts is cutting the pipe and drilling the 1/4" Hole

- 0.6 Nozzle, 0.2 layer
- 1” Pipe Mount & OBF Mount, 20% Infill 5 perimeters top/bot, 4 side. Supports for the locking tabs.If using Slic3r, Disable "Detect Bridging Perimeters", adds material to bottom of tabs.
- Plates 100% Infill perimeters 5 top/bot, 4 side
The OBF is going to break long before the mount does.

Parts
- 3/4" (1" OD)