Thingiverse

OpenForge Cut-Stone OpenLOCK Walls - Triplex

von calculuschild

412 Downloads

179 Likes

1 Makes

***EDIT 14/8/2017.*** *I have added the half-height BA wall. Otherwise the same as the other BA wall.*

***EDIT 10/8/2017:*** *I have added the IA wall. This is only wide enough to support one clip, but I reduced the polygon count anyway just for cleanliness sake.*

***EDIT 08/8/2017:*** *I have added the C wall. This will now function as both the left- and right-handed versions by simply moving the clip to the other slot; no need to print both.*

These are some walls from the OpenForge Cut-Stone OpenLOCK Walls, with the new TRIPLEX locking slots. This means each wall can be turned into the mirrored version by simply moving the OpenLOCK clip over to the other slot. Reduces the need to print out both the wall and its mirror.

There are small supports in the opening of the clip slot that you will need to remove after the piece is printed.

Also reduced the number of polygons considerably ;). The original files are *messy*. I might take some of the other walls as I need the

dnd DnD Tiles Dungeon miniatures OpenForge OpenForge2 openlock pathfinder RPG rpg Tiles stone tabletop Terrain tile wall dnd DnD Tiles Dungeon miniatures OpenForge OpenForge2 openlock pathfinder RPG rpg Tiles stone tabletop Terrain tile wall dnd DnD Tiles Dungeon miniatures OpenForge OpenForge2 openlock pathfinder RPG rpg Tiles stone tabletop Terrain tile wall dnd DnD Tiles Dungeon miniatures OpenForge OpenForge2 openlock pathfinder RPG rpg Tiles stone tabletop Terrain tile wall dnd DnD Tiles Dungeon miniatures OpenForge OpenForge2 openlock pathfinder RPG rpg Tiles stone tabletop Terrain tile wall

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

Supports nötig

Einteilig Supports nötig

Supports 2/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker