Thingiverse
OpenPilot GPS v9 holder
von jkoljo
17
Downloads
14
Likes
0
Makes
Print it out, use 8 mm rod and assemble with CA glue and a few nylon bolts and washers. This model has already successfully protected my GPS from a few crashes, and does not obstruct the signal.
The LEDs on the GPS are visible from above and side when using this holder.
The LEDs on the GPS are visible from above and side when using this holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!